No products in the cart.
FP
Showing all 7 results
- Seals
HIGH PRESSURE OIL SEALS
The rotary shaft oil seal is an indispensable component in lubricated rotating equipment and must be chosen with caution in order to ensure that the correct design and materials are used to provide a long-lasting life for the rotating equipment.
These variations of the G and M type seals are engineered to withstand pressure up to 10 BAR (1 MPa), although this limit has been exceeded in some applications. These seals are available with or without an additional dust lip. The G type and its high pressure variants show a metal insert covered by rubber, while the M type and its variants offer a bare metal body on the outside diameter.
SKU: n/a - Seals
OIL FILM BEARINGS
Primary shaft oil seals for oil film bearings. The BBS® oil seals are available in both DF and MX style to fit every customers’ requirement.
Used in steel mill: back-up rolls (hot and cold rolling mills). The BBS® oil seals can be supplied together with the corresponding Water Seal, or with specific V-Rings (secondary seal).
SKU: n/a - Seals
ROTARY SHAFT OIL SEAL
The rotary shaft oil seal is an indispensable component in any lubricated rotating equipment.
The •FP• oil seals provide the right solution to every sealing problem.
•FP• rotary shaft oil seals are produced according to modern engineering techniques with high-performing materials, as requested by industry specifications.
SKU: n/a - Seals
V-RINGS
Endless all-rubber face seal produced up to 2.100 mm in one single piece and joint-vulcanized for larger diameters. It works as a front seal and it is the perfect solution to prevent contamination from dirt, dust, or water. It can be used as a secondary seal to protect the primary seals.
The V-Ring is a seal of easy use and assembly since it is self-retaining on the shaft and does not need a special finishing grade and tolerance. The contact area can have a roughness from Ra 0.5 to Ra 1.6 according to the speed and the fluids to be sealed.
SKU: n/a - Seals
WIPER SEALS
Rod wipers for alternative linear movements have been designed to give first-class protection to seals and driving bodies in hydraulic and pneumatic cylinder applications.
The main function of the rod wiper is to keep the rod clean from any possible impurity.
The •FP• rod wipers have a chamfer on the outside diameter to facilitate the press fitting into the housing. To simplify the installation, the bore should have a chamfer as per DIN 3760.
SKU: n/a
